ZLPK - LP05/14/11 line printer test

	ABSTRACT:
		This program verifies proper operation of the LP05, LP14 line printer and its associated M7258 control unit.

	HARDWARE REQUIREMENTS:
		PDP-11 CPU, 8 KW memory, console terminal.

	SOFTWARE:
		Error tags will be listed as ''ERRXX'' where XX is error number
		Additional information may be obtained from the listing.

	OPERATING PROCEDURES:
		Starting address:
			200 initial starting address
			600 to skip manual intervation.

	SWITCH SETTINGS:
		SW 15	=1  loop on error (in test 1 only)
		SW 14	=1  optional DAVFU available
		SW 13	=1  (up) 96 character set
			=0  (down) 64 character set
		SW 12	=1  loop on test
		SW 11	=1  send only one character to line printer in scope driver - then halt
		SW 10	=1  (up) LP14
			=0  (down) LP05/LP11
		SW 09	=1  inhibit error reports
		SW 00	=1  used for print speed manual timing if no KW11-L or KW11-P available

	RUN TIME:
		1 pass takes approximately 5 min.

	NOTES:
		Individual tests and their starting address:
			200  normal start address (with manual intervention)
			400  print speed test using manual timing
			404  print speed test using KW11-L
			410  print speed test using KW11-P
			414  check top of form switch settings
			600  interface and data path test (general print test)
			700  scope driver routine
			720  scope driver routine without line feed

		For further information refer to the listing.

		*** LP06 can also be tested with this test ***